En-35
EnglishFrançaisDeutschEspañol
3
Loosen the two screws ( mark)
and lift out the lamp unit.
4
Change the lamp unit.
Do not touch the glass inside the unit.
Dirt or fingermarks on the glass may reduce the
brightness of the lamp.
Changing the Lamp
5
Replace the lamp unit and lamp
cover following the disassembly
procedures in reverse order.
6
Insert the power connector into
the power terminal.
7
Press the POWER button.
The all monitors flash for a few seconds.
The lamp timer is initialized to [0 hours].
To Next Page
Loading...