Fujitsu PalmSecure SDK V02 - Page 22

Chapter1 Preliminary Steps before Installing the Sensor Driver
12
◆ Sensor Driver for Extended Function (Linux Version)
Hardware and Software
Requirements
Description
Hardware
Requirement
CPU
Intel® Core
™
2 Duo 2.40GHz or more
(must also comply with the recommended value for the given OS )
Memory
(Note 1)
1GB or more
(must also comply with the recommended value for the given OS)
USB
USB 2.0 only
HDD space
(Note 2)
3 MB or more
Sensor
・
PalmSecure Sensor
・PalmSecure Sensor V2
For information on the firmware version level on the Sensor
unit, refer to the "System Development Guide".
Software
Requirement
OS (Note 3)
・
Linux (x86)
(kernel 2.6.32 or later)
Sensor driver
(Note 4)
Contact the sales representatives for the availability.
Note 1) The Sensor driver requires 3MB or more memory.
3MB is required for each Sensor (2 Sensors require 6MB) when
connecting multiple Sensors.
>See> For information on multiple Sensor connection, refer to the "System
Development Guide" and "Authentication Library Reference Guide".
Note 2) Minimum required space for the Sensor driver.
3MB is required for each Sensor (2 Sensors require 6MB) when
connecting multiple Sensors.
>See> For information on multiple Sensor connection, refer to the "System
Development Guide" and "Authentication Library Reference Guide".
Note 3) Operations of the Sensor driver are confirmed in the following
environments.
Linux : CentOS 6.4 [kernel: 2.6.32-358.el6.i686, glibc: 2.12]
Please verify the operations yourself if your environment is other than
the above.
Operations have not been tested in virtual environments.
Please verify the operations yourself if you are using this product
in a virtual environment.
★Tip USB driver
The USB driver is included in the OS as part of the operating system.