Chapter4 Applying Modification to the Sensor Driver Manually which is Installed by Using Archive version
4.1 Applying Modification to the Sensor
Driver Installed in Windows XP / Vista /
7 Environments Manually
This section describes how to apply modification to the Sensor driver installed in
Windows XP / Vista / 7 environments by using Archive version manually.
!Caution If a modification is applied manually
Note that device information of the Sensor driver including the version
level information displayed in Device Manager is not updated.
>See> For information how to check version level information of the Sensor
driver, refer to the "System Development Guide".
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
Step1 Ensure that the Sensor is not connected to the target hardware.
★Tip When you cannot take off the Sensor
Ensure that the Sensor is out of use.
Step2 Log in as Administrator.
Step3 Extract the downloaded archive version and copy the following files
from the folder created by the extraction to the hardware where the
Sensor driver is installed to overwrite the existing files.
The copy files and the folders to which the files copied are below.
Copy File
Folder to which file is copied
Windows (x86) Environment
Windows (x64) Environment
WINDOWS\system32\drivers\
―
―
To Next Page
Loading...