Control elements
On/Off button
When the server blade is switched off, it can be switched on again
by pressing the On/Off button.
When the server blade is operating, pressing the On/Off button will
switch off the server blade .
V CAUTION!
Risk of loss of data!
I The On/Off button does not disconnect the server blade from
the mains voltage. To disconnect it from the mains
completely, remove it from the system unit.
ID ID button
Lights up (blue) on the front of the server blade when the ID button
is pressed.
If the ID button is pressed for more than 5 seconds, released and
pressed again within 1 second, an NMI is issued.
To Next Page
Loading...
