BX900 S1 Operating Manual 45
Installing the hardware
Ê Mark the position of the bottom edge of the system unit on the support
uprights.
Figure 3: Attaching the support brackets
Ê Position the support brackets at the relevant height on the rear left support
upright (place knob in the corresponding hole) and secure them using four
centering screws (1).
Ê Fasten the holding-down clamp at the upper end of the support bracket
using two centering screws (2).
Ê Fasten the second holding-down clamp at the same height as the first one
to the rear left support upright using two centering screws.
/
0
/
/
To Next Page
Loading...
