CX2550/60/70 M4 Operating Manual 67
8 Troubleshooting and tips
V CAUTION!
Follow the safety instructions in the "Safety notes and regulations"
manual or " 安全上のご注意 " and in chapter "Important information" on
page 33.
If a fault occurs, attempt to resolve it using the measures described:
– in this chapter,
– in the documentation for the connected devices,
– in the help systems of the software used.
8.1 Power-on indicator remains unlit
The power-on indicator remains dark after you switch on your device.
Power cable incorrectly connected
Ê Make sure that the power cable(s) is/are correctly connected to the server
node and the grounded power outlet(s).
Power supply overloaded
Ê Disconnect the server node power plug(s) from the grounded power
outlet(s).
Ê Wait a few minutes before you plug it/them into the grounded power outlet(s)
again.
Ê Switch on your server node.
8.2 Server node switches itself off
Server Management has detected an error
Ê Check the error list of System Event Log in ServerView Operations Manager
or in the iRMC S5 web interface, and attempt to eliminate the error.
To Next Page
Loading...
