4
Checking location before installing the server
For details on installing the rack, refer to the "Installation
Guide for the RACK" and the manual provided with the
rack.
n
Conditions
When installing this server avoid the following areas.
- Humid, dusty, or oily areas
- Poorly ventilated areas
- Areas close to re or other sources of heat
- Areas close to water
- Areas close to direc t sunlight or near heating
appliances
- Areas with a temperature of below 10°C or above 35°C
- Areas with humidity of less than 20% or more than
80%
- Salty areas
- Areas where corrosive gas is generated
- Areas where cables become trip hazards
- Areas where strong magnetic elds are generated,
such as near TVs and speakers
- Areas where the device is not stable and could tip
over and hurt somebody
- In dusty area, dust will quickly stick to the front and back-
side of the server. Since this can cause failure, changing
the installation place is recommended.
- Noise level of this server is measured at 63dB. It is rec-
ommended to place the server in an exclusive room. Use
the server with care if it is placed in an ofce.
- Be sure to secure racks and connect stabilizers to pre-
vent the device tipping over.
n
Installing the server to the rack
1
Open both the front and rear doors of
the rack.
2
Pull out the inner rail from the slide
rail.
3
Attach the inner rails on the right and
left side of the server.
4
Loosen the rear slide rail screws.
5
Attach the slide rails to the right and
left of the rack.
1.
Attach the slide rails to the rst and the
third holes from the bottom of the server.
2.
Tightly fasten the loosened rear slide rail
screws.
To Next Page
Loading...
