Fujitsu Primergy RX200 S4 User Manual

1
PRIMERGY RX200 S4 User's Guide
Areas Covered
Before Reading This Manual
This section explains the notes for your safety and conventions used in this manual.
Chapter 1
Overview
This chapter explains component names and basic operations of this server, as well as an
overview of the software provided with this server. In addition, the workflow, from placing the
server to starting the operation, is also described.
Chapter 2
Checking before OS Installation
This chapter explains the preparation on the server and cautions necessary before OS
installation. Please read this chapter before starting installation.
Chapter 3
OS Installation
This chapter explains how to install the OS in the server using ServerStart.
Chapter 4
Operations after OS Installation
This chapter explains the operations to be performed after OS installation. Be sure to perform
those operations before operating the server.
Chapter 5
High Reliability Tools
For stable PRIMERGY server operations, we recommend that high reliability tools be installed.
This chapter explains the installation and necessary settings of high reliability tools.
Chapter 6
Installing Internal Options
This chapter explains how to install internal options.
Chapter 7
Configuring Hardware and Utilities
This chapter explains how to make the environment settings necessary to operate the server and
how to use each utility.
Chapter 8
Operation and Maintenance
This chapter explains the operations that become necessary after starting to use this server as
well as daily care and maintenance.
Appendix
This appendix explains the specifications for the server and for its internal options.

Fujitsu Primergy RX200 S4 Specifications

General

Brand	Fujitsu
Model	Primergy RX200 S4
Category	Server
Language	English

Summary

Chapter 1 Overview

1.1 RX200 S4

Describes the features and models of the PRIMERGY RX200 S4 server.

1.2 Supplied Software

Details the software provided with the server, including ServerStart.

Chapter 2 Checking before OS Installation

2.1 Preparation on the Server

Covers installing internal options and hardware settings.

2.2 Selecting an Installation Method

Discusses OS installation methods supported by ServerStart.

2.3 Precautions on Installation

Provides notes and cautions before OS installation.

Chapter 3 OS Installation

3.1 Quick Installation Mode

Explains the simple and quick OS installation process.

3.2 Expert Mode

Details the advanced OS installation process with manual partitioning.

Chapter 4 Operations after OS Installation

4.1 Memory Dump/Paging File Setting

Describes how to configure memory dump and paging files.

4.2 Creating Backup Data for System Recovery

Explains how to create system backup data.

4.3 Storing the System Configuration Information

Covers saving BIOS and Remote Management Controller information.

4.4 Creating Maintenance Tools and Driver Disks

Explains how to create maintenance and driver disks.

4.6 LAN Driver Advanced Setup [BACS]

Details advanced setup for Broadcom Advanced Control Suite.

4.7 LAN Driver Advanced Setup [Intel® PROSet]

Chapter 5 High Reliability Tools

5.1 RAID Management Tool

5.2 Server Monitoring Tool [ServerView]

5.3 Maintenance Support Tool [HRM/Server]

5.4 Solving Problems Early [DSNAP]

Chapter 6 Installing Internal Options

6.3 Installing the CPU

6.4 Installing Memory Modules

6.5 Installing Expansion Cards

6.6 Installing an Internal DVD-ROM Unit

6.7 Installing Internal Hard Disk Units

6.8 Installing a Power Supply Unit

Chapter 7 Configuring Hardware and Utilities

7.1 Jumper Pins/Switch Block Settings

7.2 BIOS Setup Utility

Chapter 8 Operation and Maintenance

8.1 Daily Maintenance

8.2 Troubleshooting

Provides resolutions for hardware, error messages, and software issues.

8.3 System Event Log

8.4 Security

8.5 Backup

8.6 Restoring the System

8.7 Reinstalling the OS

8.8 Maintenance Service