Fujitsu Primergy RX200 S4 - How to Install Internal 3.5-Inch Hard Disk Units

166
Chapter 6 Installing Internal Options
 For SAS model (2.5-inch storage bays)
 For SATA model
Package
 Before installing the internal hard disk unit, see "Appendix B.4 Internal Hard Disk Units" (p.248) to
check the packaged contents.
 Replacing defective internal hard disk units (for array configuration
only)
When an array system is configured, if one hard disk unit fails, you can replace it and perform recovery
functions without turning off the power of the server and peripheral devices (hot swap/hot plug support).
For details, refer to the manual on the "Array Controller Documents & Tools CD".
6.7.3 How to Install Internal 3.5-inch Hard Disk Units
This section explains how to install internal 3.5-inch hard disk units.
1 Open the rack door.
"1.4.1 Opening the Rack Door" (p.29)
2 Turn off the server and all peripheral devices, and unplug all power cables from
the server.
"1.4.3 Turning Off the Server" (p.32)
3 Touch a metal part of the server to discharge static electricity from your body.
table: List of installable internal hard disk units
Product name Product ID Overview
HDD SAS 10k 73GB hot plug 2.5inch PG-HDD71B 73.4GB, 10,000rpm, SAS 2.5-inch,
hot plug support
HDD SAS 15k 73GB hot plug 2.5inch PG-HDD75B 73.4GB, 15,000rpm, SAS 2.5-inch,
hot plug support
HDD SAS 10k 147GB hot plug 2.5inch PG-HDD41B 146.8GB, 10,000rpm, SAS 2.5-inch,
hot plug support
table: List of installable internal hard disk units
Product name Product ID Overview
HDD SATA 7.2k 80GB hot plug 3.5inch PG-HDF87B 80GB, 7,200rpm, SATA 3.5-inch,
hot plug support
HDD SATA 7.2k 160GB hot plug 3.5inch PG-HDF67B 160GB, 7,200rpm, SATA3.5-inch,
hot plug support
HDD SATA 7.2k 500GB hot plug 3.5inch PG-HDF57B 500GB, 7,200rpm, SATA 3.5-inch,
hot plug support