132
Chapter 6 Installing Internal Options
6.2 Attaching/Removing the Top
Cover
When installing internal options, remove the top cover.
See below for how to remove the top cover.
6.2.1 How to Remove the Top Cover
1 Open the rack door.
"1.4.1 Opening the Rack Door" (p.29)
2 Turn off the server and all peripheral devices. Also unplug all power cables from
the server.
"1.4.3 Turning Off the Server" (p.32)
3 Loosen the two screws on the front of the server.
• Before attaching or removing the top cover, turn off the server and all
peripheral devices. Also unplug all power cables from the server. Failure to do
so may cause electric shock ("1.4.3 Turning Off the Server" (p.32)).
• Use stabilizers to prevent the rack from tipping when installing the rack.
Pulling the server out of the rack without installing stabilizers may cause the
rack to tip over.
To Next Page
Loading...
