191
PRIMERGY RX200 S4 User's Guide
LAN Settings submenu
Use this submenu to set the LAN when remote controlled by the Remote Management Controller.
7.2.11 Security Menu
The Security menu sets the security options.
table: Items on the LAN Settings Submenu
Item Setting Description
DHCP • Disabled (Initial value)
• Enabled
Sets whether or not to acquire LAN IP address of
iRMC from the DHCP server.
Local IP address
This item can only be set when the [DHCP] setting is "Disabled".
Sets the IP address of iRMC.
Subnet mask
This item can only be set when the [DHCP] setting is "Disabled".
Enter the subnet mask of the onboard LAN specified in [Local IP address].
Gateway address
This item can only be set when the [DHCP] setting is "Disabled".
Enter the gateway address of the onboard LAN specified in [Local IP address].
Service LAN Enabled (Unchangeable) Sets whether or not to enable Service LAN.
Service LAN Port
• Service (Initial value)
• Shared
Sets Service LAN.
PhoenixBIOS Setup Utility
Item Specific Help
Advanced Security Server ExitMain
Setup Password:
System Password:
Set Setup Password:
Setup Password Lock:
Set System Password:
System Password Mode:
System Load:
Setup Prompt:
Virus Warning:
Flash Write:
Not Installed
Not Installed
[Press Enter]
[Standard]
[Press Enter]
[System]
[Standard]
[Enabled]
[Disabled]
[Enabled]
To Next Page
Loading...
