196
Chapter 7 Configuring Hardware and Utilities
7.2.14 Memory Status Submenu
This submenu appears when selecting [Memory Status] from the [Server] menu.
Use this submenu to set whether or not to allow the use of the installed memory modules.
table: Items on the Memory Status Menu
Item Setting Description
Memory Module 1A Enabled (Unchangeable) Sets whether or not to enable the use of the memory
modules in memory slot 1A to 3D.
If "Disabled" or "Failed" is displayed, replace the
faulty memory module and then change the setting
to "Enabled".
Memory Module 2A
Memory Module 3A
Memory Module 1B
Memory Module 2B
Memory Module 3B
Memory Module 1C
Memory Module 2C
Memory Module 3C
Memory Module 1D
Memory Module 2D
Memory Module 3D
PhoenixBIOS Setup Utility
Item Specific HelpMemory Status
Server
Memory Module 1A
Memory Module 2A
Memory Module 3A
Memory Module 1B
Memory Module 2B
Memory Module 3B
Memory Module 1C
Memory Module 2C
Memory Module 3C
Memory Module 1D
Memory Module 2D
Memory Module 3D
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
To Next Page
Loading...
