199
PRIMERGY RX200 S4 User's Guide
7.2.17 Exit Menu
This menu exits the BIOS Setup Utility.
Note the followings when returning a setting value to an initial value by pressing the [F9] key.
• When an onboard software RAID is not used, check the setting value for the "S_ATA Mode" item of
"
ATA Controller Config submenu" (p.185) in the [Advanced] menu is "Compatible". When it is
set to "RAID", the system might not start.
• When using an onboard software RAID, "Embedded RAID CD/DVD-ROM" is displayed in the "Boot
Sequence" item of "7.2.4 Boot Options Submenu" (p.181).
Check that the boot order has no problem.
If the boot order of the Embedded RAID CD/DVD-ROM is the lowest, the system might not be
booted from a CD/DVD.
table: Items on the Exit Menu
Item Description
Save Changes & Exit Saves the current settings to CMOS and closes the BIOS Setup Utility. At the same
time the server restarts.
Discard Changes & Exit Exits the BIOS Setup Utility without saving the current settings. The previously
saved settings remain valid.
Get Default Values Reads and displays the default values of this server.
The value set at the previous time is displayed for the value in "
LAN Settings
submenu" (p.191).
"Local IP address", "Subnet Mask", and "Gateway Address" in the LAN Settings
submenu are not reset.
Also, all items in the LAN Settings submenu are not set again.
Load Previous Values Reads and displays the values valid at the time BIOS Setup Utility was loaded.
PhoenixBIOS Setup Utility
Item Specific Help
Advanced Security Server ExitMain
Save Changes & Exit
Discard Changes & Exit
Get Default Values
Load Previous Values
To Next Page
Loading...
