185
PRIMERGY RX200 S4 User's Guide
ATA Controller Config submenu
Sets the Serial ATA.
USB Rear • Enabled (Initial value)
• Disabled
Sets whether or not to use the USB connector on the
back.
ATA Controller Config Configures additional settings.
"
ATA Controller Config submenu" (p.185)
Mouse Controller Auto Detect
(Unchangeable)
Sets whether or not to use the mouse connected to
the mouse connector.
Onboard Video Enabled (Unchangeable) Sets whether or not to enable the onboard video
controller.
LAN Controller LAN1&2 (Unchangeable) Sets whether or not to enable the onboard LAN
controller (channel 1, or channel 1 & 2).
LAN1 Remote Boot • Disabled (Initial value)
•PXE
• iSCSI
Sets whether or not the OS may be loaded from the
server. This function is used especially when no
floppy disk drive or hard disk drive are installed, or
when both are turned off.
LAN2 Remote Boot
table: Items on the ATA Controller Config submenu
Item Setting Description
S_ATA Mode Compatible
(Unchangeable)
Sets the Serial ATA Controller mode in RAID
configured SAS models, SAS and SATA models
where RAID is not configured, and diskless models
where RAID is not configured.
RAID (Unchangeable) Sets the Serial ATA Controller mode if RAID is
configured in the SATA model.
P_ATA Maps To Disabled (Unchangeable) Sets the Parallel ATA controller mode.
Primary IDE Channel Enabled (Unchangeable) Sets whether or not to enable the Primary IDE
Channel.
Secondary IDE Channel Enabled (Unchangeable) Sets whether or not to enable the second IDE
Channel.
table: Items on the Peripheral Configuration Submenu
Item Setting Description
To Next Page
Loading...
