254
Appendix
C.2 Remote Power Supply Control
This section explains how to control the server power supply remotely.
The server power supply can be remote-controlled with the terminal software on the PC.
Starting up the Remote Controller
1 Start up the terminal software.
The remote control window appears.
Power state is displayed next to "Power Status:".
2 When "Please enter user name" appears, enter the user name and press the
[Enter] key.
table: Meaning of [Power Status]
Display Description
On The server is powered on.
Off The server is powered off.
****************************************
* Welcome to PRIMERGY Remote Manager *
* Firmware Revision x.xxA (x.xx) *
* SDRR *.** ID 0203 RX200S4 *
* Firmware built xxx xx xxxx xx:xx:xx *
****************************************
System Type : PRIMERGY RX200 S4
System ID : xxxxxxxx
System Name : RX200S4-2 (xxx.xxx.xxx.xxx)
System OS : xxxxxxxx
System Status: OK
Power Status : On
Please enter user name :
Please enter pass phrase :
To Next Page
Loading...
