115
PRIMERGY RX200 S4 User's Guide
3 Select [Accept] and click [Next].
4 Select all the following items, and click [Next].
The display of options differs depending on the version of Intel
®
PROSet to be installed.
• Driver
•Intel
®
PROSet for Windows Device Manager
• Advanced Network Service
5 Click [Install].
6 Click [Finish].
4.7.2 Teaming
Notes
The following are notes on using teaming via Intel
®
PROSet. For details, refer to Intel
®
PROSet help.
However, when the content of help and this manual differ, follow the instructions in this manual.
• Once a Team is created, virtual adapters will be created in the system. Do not disable or delete a
virtual adapter from the [Device Manager] or [Network Connections]. When deleting a virtual
adapter, make sure to use Intel
®
PROSet.
Do not disable or delete an actual adapter from the [Device Manager] or [Network Connections].
When disabling or deleting an actual adapter, delete it from the team using Intel
®
PROSet first before
disabling or deleting an actual adapter.
• For AFT/ALB/Static link/Dynamic link type, up to four LAN ports can be incorporated into one team
and two ports for a SFT type team.
• When the Teaming function is being used, only the following protocols can be used:
• For AFT/SFT/Static/Dynamic link type: IP, NetBEUI, IPX (NCP), IPX (NetBIOS)
• For ALB type: IP, IPX (NCP)
• When the Teaming function is being used, Windows Load Balancing Service (WLBS) and Network
Load Balancing (NLB) cannot be used.
• Up to four teams can be configured in the same system. Up to two teams can be configured for
Dynamic link.
• When using AFT/ALB/Static link/Dynamic link type, all ports in the team must be connected to the
same switch.
• When using AFT/ALB/Static link type, the spanning tree function of the switch side port must be
disabled.
• When adding/deleting a Static link/Dynamic link type member, perform such operation in a linked
down state.
• For Static link/Dynamic link type, all adapters must run at the same speed.
To Next Page
Loading...
