160
Chapter 6 Installing Internal Options
6.6 Installing an Internal DVD-ROM
Unit
This section explains how to install a internal DVD-ROM unit.
For the procedure for handling a DVD-ROM, refer to "1.4.4 Inserting and Ejecting a
CD/DVD" (
p.33).
6.6.1 Installation Location of Internal DVD-ROM Unit
Install the internal DVD-ROM unit in the CD/DVD drive on the front of the server.
6.6.2 Installable Internal DVD-ROM Units
The following DVD-ROM unit can be installed in this server.
Optional internal DVD-ROM unit package
Before installing an optional internal DVD-ROM unit, see "Appendix B.3 Internal DVD-ROM Units"
(p.247) to check the packaged contents.
• Before installing or removing an internal DVD-ROM unit, turn off the server and
all peripheral devices, and unplug all power cables from the server. Failure to
do so may cause electric shock ("1.4.3 Turning Off the Server" (p.32)).
• When installing a DVD-ROM, hold it by the side.
Applying force to the top may cause failures.
• The circuit boards and soldered parts of internal options are exposed and can
be damaged by static electricity.
Before handling them, first touch a metal part of the server to discharge static
electricity.
• Do not touch the circuitry on boards or soldered parts. Hold the metallic areas
or the edges of the circuit boards.
table: Installable internal DVD-ROM unit
Product name Product ID Remarks
DVD-ROM SATA
PG-DV106
SATA
[Front of the server]
CD/DVD drive (optional)
To Next Page
Loading...
