Fujitsu Primergy RX200 S4 - Console Redirection Submenu

198
Chapter 7 Configuring Hardware and Utilities
7.2.16 Console Redirection Submenu
This submenu appears when selecting [Console Redirection] from the [Server] menu.
Use this submenu to configure detailed settings for console redirection.
table: Items on the Console Redirection Submenu
Item Setting Description
Console Redirection • Disabled (Initial value)
• Enabled
Sets whether to enable or disable console
redirection.
Port Serial 1 (Initial value) Sets the serial port to be used for console
redirection.
This submenu appears when [Console Redirection]
is set to "Enabled".
Baud Rate • 1200
• 2400
• 4800
• 9600 (Initial value)
• 19.2K
• 38.4K
• 57.6K
•115.2K
Sets the baud rate to be used for console redirection.
This submenu appears when [Console Redirection]
is set to "Enabled".
Protocol • VT100
• VT100, 8bit
• PC-ANSI, 7bit
•PC-ANSI
• VT100+ (Initial value)
Sets the console type for console redirection.
This submenu appears when [Console Redirection]
is set to "Enabled".
Flow Control • None
• XON/XOFF
• CTS/RTS (Initial value)
Sets the flow control.
This submenu appears when [Console Redirection]
is set to "Enabled".
Mode • Standard
• Enhanced (Initial value)
Sets the range of use for console redirection.
This submenu appears when [Console Redirection]
is set to "Enabled".
PhoenixBIOS Setup Utility
Item Specific HelpConsole Redirection
Select Item
Select Menu
Change Values
Select > Sub-Menu
-/+
Enter
F1
Esc
Help
Exit
Server
Console Redirection: [Disabled]