40
Chapter 2 Checking before OS Installation
2.1.2 Hardware Settings
The BIOS Setup Utility must be used in the following cases. For details on how to use the BIOS Setup
Utility, refer to "7.2 BIOS Setup Utility" (
P. 176).
Changing the boot drive
To change the boot drive, start up the BIOS Setup Utility, select [Boot Option], and set the boot drive in
the [Boot Options] submenu under the [Main] menu.
"7.2.4 Boot Options Submenu" (p.181)
When installing Windows Server 2008 (64-bit) using ServerStart
When installing Windows Server 2008 (64-bit) using ServerStart, and when saving the configuration file
to a floppy disk, the boot priority must be changed as follows using the BIOS Setup Utility before
ServerStart startup. If the boot priority is not changed, the automatic installation stops in the middle.
Make sure to change it.
1 Turn the sever on, and start the BIOS Setup Utility.
2 Select "Boot Options" in the [Main] menu, and press the [Enter] key.
The [Boot Options] submenu window is displayed.
"7.2.4 Boot Options Submenu" (p.181)
3 Set the "Boot Sequence" setting value to put the HDD device name before the
floppy drive.
1. Embedded RAID CD/DVD-ROM (For onboard SATA RAID configuration)
2. CD-ROM Drive
3. Hard Drive
4. Diskette
5. Legacy LAN Card
4 Exit the BIOS Setup Utility, and turn the server's power off.
To Next Page
Loading...
Need help?
General