80 Operating Manual RX2520 M4
Starting up and operation
6.4 Configuring the server
This section contains information about configuring the server and installing the
operating system.
I Make sure that the power saving functions are disabled in the Power
menu of the BIOS Setup during operation.
6.4.1 Configuring the onboard SATA controller
A SATA controller is integrated on the system board. You can configure the
onboard controller either before or during installation with the ServerView
Installation Manager. Using the ServerView Installation Manager is
recommended.
I The controller has its own configuration utility. For further information,
refer to the “Embedded MegaRAID Software User’s Guide” (on the
Fujitsu manuals server under x86 Servers - Expansion Cards - Storage
Adapters - LSI SAS / SCSI RAID Controllers).
I Descriptions of operating systems not covered in the controller manual
are provided in the corresponding readme under:
http://www.fujitsu.com/global/services/computing/server/ia/driver/index.html .
http://www.fmworld.net/cgi-bin/drviasearch/drviaindex.cgi
(for Japan).
I In the system BIOS the onboard SATA controller can be configured as
"IDE", "AHCI" or "non-RAID".
To Next Page
Loading...
Need help?
General