ServerView Remote Management Frontend 11
2 Configuring the Remote
Management Frontend
You can use configuration files to make the following settings for the Remote
Management Frontend:
– Multisession support for power management and console redirection via
BMC/ iRMC/ iRMC S2 and display of the buttons for SSH access
(iRMC/ iRMC S2) and power management/console redirection
(iRMC/ iRMC S2) in the Operations Manager.
– Deletion/non-deletion of the console area on text console redirection after
termination of a console redirection session.
2.1 Configuring multisession support, SSH
access and console redirection
I The following versions of the Operations Manager and the Remote
Management Frontend must be present before you can configure the
Remote Management Frontend settings described in this section:
– Operations Manager V4.90 or higher
– Remote Management Frontend V4.90 or higher
When you install the Remote Management Frontend, a folder named Features is
automatically created in the directory
<SV-installation-directory>\ ServerView\ServerView Services\ wwwroot\ RemoteView.
In this folder, you can configure whether the following Remote Management
Frontend features are made available:
– Multisession support for BMC/ iRMC/ iRMC S2
For each managed PRIMERGY server with iRMC/ iRMC S2 or BMC, it is
also possible to open a browser window for power management and console
redirection via iRMC/ iRMC S2 or BMC.
Default value: Multisession support for BMC/ iRMC/ iRMC S2 is activated.
I Multisession support is always activated for the other interfaces made
available by the Remote Management Frontend.
To Next Page
Loading...
Need help?
General