Fujitsu ScanSnap S1300

If you have installed the software before
12
If you have installed the software before
This section explains how to troubleshoot when you failed to reinstall the software in a
computer in which the software bundled with the ScanSnap (including models other than
S1500/S1500M/S1300i/S1300/S1100) has been installed before.
■ Uninstalling the software
Uninstall the software in the following procedure.
1. If the ScanSnap is connected to the computer, unplug the USB cable
from the computer.
2. Log on as a user with Administrator privileges.
3. If an anti-virus software is running, disable the software temporarily.
ATTENTION
If you cannot disable the anti-virus software, check if the software is set to lock the application.