6
Connecting the ScanSnap
1.
Connect the AC cable to the AC adapter
(collectively called the "power cable").
2. Plug the power cable into the power
connector at the back of the ScanSnap,
and the other end to an AC outlet.
3. Remove the tape seal on the USB
connector of the ScanSnap.
4. Connect the USB cable to the USB
connector on the ScanSnap and the USB
port on your computer.
5. Open the ADF paper chute (cover) of the
ScanSnap.
⇒ The ScanSnap is powered on and the [Scan]
button lights in blue.
• Only one ScanSnap can be used by a
computer at a time.
• Use only the cable supplied with the
ScanSnap.
CAUTION
Do not use AC adapters other than the one supplied
with this ScanSnap. Doing so may cause damage to
the ScanSnap.
Manufacturer: SANKEN ELECTRIC Co.,LTD
Model number: SED80N2-24.0
Power connector
Power cable
AC outlet
• When connecting to USB hub, make sure
to connect the ScanSnap to the USB hub
which is connected to a USB port of your
computer. Use a powered USB hub (with
AC adaptor).
• If USB port or USB hub is USB 1.1,
scanning speed will slow down.
• Connect the USB cable with the USB
mark facing up.
The bottom of the ScanSnap may become
hot when the ScanSnap is used.
This heat does not affect ScanSnap
operation or cause any physical harm
directly.
Be careful not to drop the ScanSnap when
hold the bottom for carrying the ScanSnap.
[Scan] button
ADF paper chute (cover)
To Next Page
Loading...
