Fujitsu SP-1130 User Manual

Chapter 8 Operational Settings
89
Appendix
Glossary
Contents
TOP
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Index
Introduction
Setting [View Only mode]
Set the Software Operation Panel to [View Only mode] in the
following procedure.
1 Set a password.
For details, refer to "Setting a Password" (page 88).
2 Right-click the Software Operation Panel icon in the
notification area, and select [View Only mode] from the
menu.
 The Software Operation Panel enters the [View Only mode].
HINT
In [View Only mode], a check mark appears next to [View Only
mode] in the menu that is displayed by right-clicking the Software
Operation Panel icon in the notification area.

Fujitsu SP-1130 Specifications

General

ADF Capacity	50 sheets
Optical Resolution	600 dpi
Interface	USB 2.0
Scanner Type	Automatic Document Feeder (ADF)
Supported OS	Windows
Dimensions	298 x 135 x 133 mm
Paper Width	A4, Letter, Legal, A5, B5, Envelopes (DL, COM10)