Fujitsu Stylistic - Page 60

52
Stylistic ST4110 Fujitsu Tablet PC User’s Guide - Section One
To change the setting, click [Change], and
follow the instructions on the screen. [System
Properties] appears again.
5. Click [OK]. When a message appears
prompting you to restart the computer, click
[Yes].
Sharing
In this section, you set sharing of the drive,
folder, and printer.
You need to set this only when you are sharing
files or a printer with other computers on the
network.
When you share a drive, folder, or printer, you
can use these from any computer on the
network.
Setting [File and Printer Sharing for
Microsoft Networks]
1. Click [Start] -> [Control Panel]. Make sure
the Classic View is selected.
2. Double-click the [Network Connection] icon.
3. Right click the [Wireless Network
Connection], and then click [Properties]
from the menu that appears. [Wireless
Network Connection Properties] appears.
4. If [File and Printer Sharing for Microsoft
Networks] is displayed in the list:
Make sure that it is checked. If it is not
checked, check it, and click [OK]. You do
not have to perform the following steps. Go
to the next section, “Sharing Files.”
If [File and Printer Sharing for Microsoft
Networks] is not found in the list, click
[Install], and perform Step 5 and the
subsequent steps. When you click [Install],
[Select Network Component Type] appears.
5. Perform the following steps.
• Click [Internet Protocol (TCP/IP)].
• Click [Properties]. [Internet Protocol
(TCP/IP) Properties] appears.
6. Perform the following steps.
• Click [File and Printer Sharing for
Microsoft Networks].
• Click [OK]. You will go back to
[Wireless Network Connection 2
Properties], and [File and Printer Sharing
for Microsoft Networks] is added to the list.
7. Click [Close].
Sharing Files
The following example shows how to set
sharing the “Work” folder on the c: drive.
1. Click [Start] -> [My Computer].
2. Double-click the [Local Disk (c:)] icon.
3. Right click the “Work” folder, and then click
[Sharing and Security] from the menu that
appears. [Work Properties] appears.
4. Click [If you understand the security risks
but want to share files without running the
wizard, click here].
In the [Work Properties] window, the description
under [Network Sharing and security] changes.
5. Check [Share this folder on the network].
Uncheck [Allow network users to change my
files], if the shared folder is for read only.
6. Click [OK]. The folder is set shared, and the
“Work” folder icon changes.
Description
A name to identify the computer
on the network. You can specify
any name to each computer. Use
up to 15 single-byte characters.
For easier identification, use the
model name or user name.
A name of the network group. Use
up to 15 single-byte characters.
AdHoc Network: Specify the
same name to all computers
within the same network.
Infrastructure Network:
Specify workgroup name to
connect to.
Computer
Name
Workgroup
Table 10: Setting computer name
and workgroup
Item
If you have already clicked [If you
understand the security risks but want to
share files without running the wizard, click
here], this window does not appear.
Alb6_UG (50-60) 10/24/02, 11:53 AM52