Fujitsu UTY-RVN*M Series - Switch Setting Configuration; Memory Backup Setting; Dual Remote Controller Setup

- (OP005 - 12) -
WIRED REMOTE CONTROLLER WIRED REMOTE CONTROLLER
FUNCTION SETTING7.
SWITCH SETTING7-1.
DIP
Switch
SW1
Memory backup setting
SW2
Dual remote controller setting
Switch position
z
DIP Switch setting
z
Memory backup setting ●
Set to ON to use batteries for the memory backup.
If batteries are not used, all of settings stored in memory will be deleted if there is a power
failure.
(
u
...Factory setting)
SW1 Memory backup
u
OFF Invalidity
ON Validity
Dual remote controller setting ●
Set the remote controller SW2 according to the following table.
(
u
...Factory setting)
Number
of remote
controller
Primary unit
Secondary
unit
SW2 SW2
u
1 (Normal) OFF -
2 (Dual) OFF ON
1 2 31 2 3
1 2 3
Indoor unit
Remote controller cable
Primary unit
Secondary
unit
Remote controller
Junction box
(eld supply)