1. Release the power cord from cord storage hooks. (Fig. 5)
2. Extend the telescopic wand to the desired length. (Fig. 6)
3. Attach the floor nozzle to the end of the dust cup for cleaning bare floors or area rugs. (Fig. 7)
4. Insert the power plug into a wall outlet and press the on/off button located on top of the
main unit. (Fig. 8)
5. Adjust the power of the motor by sliding the suction control valve up or down. (Fig. 9)
6. Replace the floor nozzle with the crevice tool for cleaning along baseboards, ceilings and into
small spaces. (Fig. 10)
Fig. 6
Fig. 8
Fig. 10
Operating the Vacuum
Fig. 7
Fig. 9
Fig. 5
7
To Next Page
