FUNAI 39FW702 - DETAIL SETTINGS - PICTURE AND SCREEN; Screen Settings for PC Input; Picture Mode and Manual Adjustments; Advanced Picture Settings

19
Screen Settings
You can edit the screen settings in PC mode.
1 Use Ż / Ź to select [SCREEN].
[Auto Adjust]
You can change the screen settings automatically.
2 Use Ÿ / ź to select [Auto Adjust], then press
OK.
[H-Offset] / [V-Offset] / [Clock] / [Phase]
You can change the screen settings manually.
2 Use Ÿ / ź to select the item you want, then
press OK, and then appear the setting display,
adjust the setting using Ż / Ź.
Picture Adjustment
You can adjust the picture settings according to your
personal preference.
These settings are automatically stored after exiting
the picture menu.
1 Use Ż / Ź to select [PICTURE].
[Picture Mode]
2 Use Ÿ / ź to select [Picture Mode], then press
OK.
3 Use Ÿ / ź to select [Dynamic], [Standard],
[Mild] or [Personal], then press OK.
[Contrast] / [Brightness] / [Color] / [Tint] /
[Sharpness]
2 Use Ÿ / ź to select the item you want. Then
press OK, and the setting display will appear.
3 Adjust the setting using Ż / Ź.
[Color Temperature]
You can change the color tone of the picture.
2 Use Ÿ / ź to select [Color Temperature], then
press OK.
3 Use Ÿ / ź to select [Cool], [Medium] or
[Warm], then press OK.
[Noise Reduction]
You can reduce noise level.
2 Use Ÿ / ź to select [Noise Reduction], then
press OK or Ź.
3 Use Ÿ / ź to select [Off], [Low], [Middle] or
[High], then press OK.
[Dynamic Contrast]
You can set the dynamic contrast mode.
2 Use Ÿ / ź to select [Dynamic Contrast], then
press OK.
3 Use Ÿ / ź to select [On] or [Off], then press OK.
• While adjusting each setting, you can change the setting
item using Ÿ / ź.
Move SelectMenu Exit
Auto Adjust
H-Offset
V-Offset
Clock
Phase
SCREEN
30
30
30
0
Move SelectMenu Exit
Picture Mode
Contrast
Brightness
Color
Tint
Sharpness
Color Temperature
Noise Reduction
Medium
Middle
Standard
50
50
50
50
30
PICTURE
Dynamic Contrast
Off
• You can change picture mode easily using P MODE on the
Remote Control. Press P MODE repeatedly to select the
picture mode you want. In this function, you can also assign
the picture mode individually to each input mode.
• You can adjust the settings, if you set [Personal] in
[Picture Mode].
• While adjusting each setting, you can change the setting
item using Ÿ / ź.