FUNAI DRV-B2734 - To Skip a Preset Channel; To Select a Channel

19
Getting Started
EN
• If “Skip” is set to “ON,” select “Skip” using
[Cursor U / D], then press [ENTER]. Select
“OFF” using [Cursor U / D], then press
[RETURNR].
• If you want to decode scrambled signals, select
“Decoder” using [Cursor U / D], then press
[ENTER]. Select “ON” using [Cursor U / D],
then press [RETURN R].
• To store another channel, repeat steps 4 to 7.
8 After completion, press [SETUP] to
exit.
To select a channel
Notes on using the Number buttons:
• Enter channel numbers as a two-digit number for the
quickest result. For example, to select channel 6,
press [0] and [6]. If you only press [6], channel 6 will
be selected after 2 seconds. You can only select
channels 1 to 99.
• You can select the external input mode “AV1,” “AV2”
or “AV3.”
• To select “AV1,” press [0], [0], [1].
• To select “AV2,” press [0], [0], [2].
• To select “AV3,” press [0], [0], [3].
To skip a Preset channel
You can set the unit to skip channels you can no
longer receive or seldom watch when you access
channels using [PROG. U / D].
1 Follow steps 1 to 3 in “Manual
tuning.”
2 Select “Position” using
[Cursor U / D], then press [ENTER].
3 Select the position number you wish
to skip using [the Number buttons]
or [Cursor U / D], then press
[RETURN
R].
4 Select “Skip” using [Cursor U / D],
then press [ENTER].
5 Select “ON” using [Cursor U / D],
then press [RETURN
R].
• To skip another channel, repeat steps 2 to 5.
6 Press [SETUP] to exit.
Move
You can replace two channels.
1 In stop mode, press [SETUP].
2 Select “Advanced Setting Menu”
using [Cursor U / D], then press
[ENTER].
If it has already appeared, proceed to step 3.
3 Select “Channel” using
[Cursor U / D], then press [ENTER].
4 Select “Move” using [Cursor U / D],
then press [ENTER].
5 Select the position number of which
you want to change the channel
using [Cursor U / D], then press
[ENTER].
You cannot select a position number where
“– – –” appears next to the number, because
“Skip” is set to “ON” for that position number.
6 Move the channel to another position
number using [Cursor U / D], then
press [ENTER].
• To move another channel, repeat steps 5 to 6.
7 Press [SETUP] to exit.
DRV_B2737_B2734.book Page 19 Thursday, March 31, 2005 10:04 PM