Technical data:
Connection values: 230V / 115V AC (50..60 Hz) 180 W
Resolutions:
Measured values:
Fat: 0.01 %
SnF: 0.01 %
Calculated values:
Protein: 0.01 %
Lactose: 0.01 %
Freezing point:0.001 °C
Maximum values:
dependent on the calibration, however not larger than:
Fat: 14.99 % Lactose: 9.99 %
Protein: 9.99 % SnF: 14.99 %
Minerals:
Freezing point: unlimited, as only calculated
Sample flow rate: up to 100/h (typical 60/h)
Sample volumes: 10 ml
Interfaces: 1 x parallel, 1 x serial (RS 232/ 9600 Baud) 6 Volt power
supply for thermal printer (Item No. 7151)
Dimensions: 30 x 24 x 33 cm (W x H x D)
Weight: approx. 5.kg (net)
18 LactoFlash 31. Januar 2013
What to do in the Case of Milk Precipitations 15
Entrainment 16
Error Messages / Troubleshooting 16
Technical Data 17
Order Data
Spare und consumable parts 17
Guarantee Conditions 18
Important note
In case of transporting or the device must be stored, the
measuring cells must be rinsed before with air. Please start
the "Rinsing" with air instead off rinsing liquid. After 3-4
rinsing circles the measuring cells including the whole device
are ready for despatch. This is very important when ambient
temperatures are less than 0 °C!
LactoFlash 31. Januar 2013 3
To Next Page
Loading...
