Funkwerk bintec R230a User Manual

System bintec User’s Guide
35
Submenu Time and Date
6
6 Submenu Time and Date
The fields of the TIME AND DATE submenu are described below.
System time You need the system time for tasks such as correct timestamps for system mes-
sages, accounting or IPSec certificates.
You can derive the system time:
■ automatically, e.g. via different time servers.
■ manually in the gateway.
The menu for the configuration of the time retrieval is accessible via the SYSTEM
menu (SYSTEM ➜ TIME AND DATE).
To assure that your gateway uses the correct current time, it is recommended
to configure time servers.
R232bw Setup Tool Funkwerk Enterprise Communications GmbH
[SYSTEM][TIME]: Control System Time and Date MyGateway
Current System Time: Wed 2005/Feb/28 19:19:37 setby: None
Change System Time: 2005/Feb/28 19:19:17 CHANGE
Time Update Interval : 86400 Seconds
Update System Time from ISDN : disabled
System Time Offset from GMT : 0 Seconds
Time Servers:
Name/Address Protocol
1: SNTP
2: SNTP
3: SNTP
SAVE CANCEL
Note
If a method for deriving the time automatically is set in the gateway, the values
obtained in this way have higher priority. Any system time entered manually is
overwritten.

Funkwerk bintec R230a Specifications

General

Brand	Funkwerk
Model	bintec R230a
Category	Gateway
Language	English