WWW.FUNNMTB.COM
RIPPER CLIPLESS PEDALS 2022.08.20 / REV. 1
LEFT
LEFT RIGHT
RIGHT
LEFT
RIGHT
Socket wrench 4mm
8mm
34 Nm
34 Nm
Thank you for purchasing this RIPPER CLIPLESS PEDALS.
Please read the instructions thoroughly before attempting to install this item.
Proper installation is required for compliance with FUNN’s warranty policy.
． Hex key 3mm
． Hex key 8mm
． Socket wrench 4mm
8mm
INSTALLATION AND USE
RIPPER CLIPLESS PEDALS
contents
tools required
． Pedals
． Traction pins
． Cleat kit
． Socket wrench 4mm
PEDAL installation
SET
PCS
1
16
1
1
SET
PC
Begin by identifying the left and right pedals. The left side
pedal has a single indented line surrounding the spindle.
1. Install the traction pins with the 4mm socket wrench.2.
Lightly lubricate the axle threads with anti-size grease before installing to the crankset.
Thread the axle into the crank hole with your fingers. Please follow the illustrated directions for tightening the left and
right pedals.
Insert a 8mm hex key to further tighten the screw to 34Nm (300 lb-in) torque and avoid excessive force.
3.
4.
5.
To Next Page
Need help?
General
