Furious FPV F-35 LIGHTNING - How to Use NAV LAUNCH (Auto Take Off) Function

32
Step 2: Configure INAV Configurator
1. Open INAV Configurator and go into Failsafe tab
2. Enable RTH on the setting stage
How To Use NAV LAUNCH (Auto Take Off) Function
Video: How to use NAV LAUNCH (Auto Take off) with F-35 Lightning FC
Step1: Open “INAV Configurator”  Select “Mode” tab  drag to NAV LAUNCH
function, click Add Range and select CH channel for switch that you want to use this
mode
Step2: Set switch to NAV LAUNCH mode prior to arming (note that it won't actually
enable until arming)
Step3: ARM the plane. Motor should start spinning at min_throttle (if MOTOR_STOP
is active, motor won't spin)
*Note:
 NAV LAUNCH is automatically aborted after 5 seconds or by any pilot touch on
PITCH/ROLL stick
 Verify that motor don't respond to throttle stick motion