Furrion FOS43TASK User Manual

31
Install Cameras
Install Side Cameras & Rear Camera withMarker Light
Product overview
Side (Left/Right) cameras with marker light
12 IR LED Light
LED Indicator
Monitor Pairing
Button
Light Sensor
Lens
Marker Light
Rear camera
8 IR LED
LED Indicator
Lens
Monitor Pairing
Button
Light Sensor
Marker Light
Antenna
Prepare
● Prepare tools you may need, including # 1 and #2 Phillips head screwdrivers, sealant,
insulation tape, pencil and/or a 5/8”drill bit (needed only when drilling a new hole).
Mount bracket
Note: Skip this section if your RV is pre-installed with a bracket for camera installation.
IMPORTANT: Before any installation and wiring operation, remove the key from the ignition
and isolate the 12V / 24V power source.
Always seek professional assistance if you are unsure about the installation and wiring operation.
1. Determine the mounting location on your RV. Ensure that there is no obstacle blocking the
camera view. To avoid drilling new holes, you are recommended to replace the original
marker lights with Furrion products directly as shown below:

Furrion FOS43TASK Specifications

General

Brand	Furrion
Model	FOS43TASK
Category	Digital Camera
Language	English