1. INSTALLATION
4
Installation on a platform
There are 5 steps necessary to install the radar sensor. The illustration below summa-
rizes the installation.
1. Set the supplied mounting template to the mounting location, then drill four fixing
holes in the mounting location.
Note: The holes must be parallel with the fore and aft line.
2. Put the radar sensor on the platform with the bow mark () on the sensor aligned
with the ship’s bow.
3. Use hex bolts (see the table below for bolt length), flat washers and spring wash-
ers to secure the radar sensor to the platform. The torque for the bolts is 19.6 to
24.5 N•m.
Platform thickness and bolt to use
Platform thickness Size of bolts to use
6 - 10 mm M1025 (Supplied)
Over 10 mm Local supply
STERN
BOW
Align bow mark (Δ) on
radome with ship’s bow.
Power/LAN cable (1 m)
Holes drilled referring to the outline drawing
and the mounting template in this manual.
Platform
Hex bolt (M10×25)
Spring washer
Flat washer
Bow
Mounting template
Note: This template may have expanded or
shrunk slightly
.
Please confirm dimensions before use.
ὀព㻦㻌㻌ᮏᆺ⣬䛿ಖᏑ≧ែ䛻䜘
䜚ⱝᖸఙ⦰䛩䜛ሙྜ䛜䛒䜚䜎䛩䚹
㻌㻌㻌㻌㻌㻌㻌㻌㻌⏝䛾㝿䛻䛿ᑍἲ䜢☜ㄆ䛧䛶䛟䛰䛥䛔䚹㻌
Dril
l
11mm (0.43'') hole in dia. (four positions)
䃥㻝
㻝㼙㼙㻌䜻䝸㻌㻔㻠䞃ᡤ㻕
㻝㻢㻜㼼
0.
5mm (6
.3'')
㻝㻢㻜㼼0.5m
m
(6.3'')
㻢㻜mm (2.3
6'')
CENTER O
F ANT
ENNA ROT
ATION
䜰䞁䝔䝘ᅇ㌿୰ᚰ
BOW
⯪㤳᪉ྥ
December 2014
Printed
in Japan
C32-0070
2-A1
㻰㻾㻿䝅䝸䞊䝈䝺䝗䞊䝮䝉䞁䝃䞊
ᆺ⣬
DRS Series Radome Sensor
Template
䢲䢲䢲䢳䢸䢹䢶䢷䢺䢳䢲
Platform
Sensor base
Flat washer
Hex bolt
Spring washer
Determine the length of bolts
according to platform thickness.
To Next Page
Loading...
