Furuno FAR-2107 Series - Changing of IP Address

4.4
Initialize Setting
Initialize Setting Initialize Setting
Initialize Setting
4-35
2. Changing of IP address
Never change the IP address except for special types specified below.
If the IP address is improperly changed, the system may fail to work properly.
In order to allow the Inter switch function of the radar to work properly between
networks, it is required to set up the IP address specified to the network, subnet mask,
default gateway and destination. Connection should be one-to-one connection according
to the 100 Base-Tx. Detailed equipment and specifications are not described here.
The IP address can also be changed on CU-200. (Only one network.) It cannot be shared
among multiple networks.
Note that IP address of CU-200 can be rewrite, and the program versions of CU-200 are
0359209-01.02 or later.
Fig. 4.4.14 Example of Network Connection
Note 1: Changing the IP address of the radar
Procedure
1. Press the [Menu] key 5 times while holding down the [1] key to open the
“INITIALIZE” menu.
2. Select the radar number of the own radar in “INITIALIZE -> 4: INSTALLATION
-> 4: RADAR NO”.
3. When the message “Completed!! Power on restart.” is displayed, restart the power.
4. Press the [2], [3] and [4] keys in order while holding down the [1] key to call up the
“FACTORY” menu.
5. Press the [ENT] key 5 times while holding down the [1] key to call up the
“INITIALIZE” menu.
FAR-2xx7
Series
FAR-2xx7
Series
Router
Gateway:
172.31.3.254
IP: 192.168.1.1
Gateway:
192.168.1.254
RADAR NO.(ANT) :1
IP ADDRESS :172.31.3.6
SUBNET MASK :255.255.0.0
GATEWAY :172.31.3.254
DESTINATION :192.168.1.1
RADAR NO.(ANT) :2
IP ADDRESS :192.168.1.1
SUBNET MASK :255.255.0.0
GATEWAY :192.168.1.254
DESTINATION :172.31.3.6
IP: 172.31.3.6
Note:
The DESTINATION setting
has to set the IP address o
f
the other radar.