Furuno FAR-2107 Series - Block Diagram of Monitor Unit

7.5 Monitor Unit
7-74
7.5.2 Block diagram of monitor unit
1. MU-201CR
The power-on signal of the monitor unit is inputted into the DVI I/F board as signals of
#14 pin (+5 V POWER) of the DVI connecter. The DVI I/F board outputs “RC+/-”
signals based on these signals to control ON/OFF of the power supply unit
Fig. 7.5.1 Block diagram of MU-201CR (AC)
Fig. 7.5.2 Block diagram of MU-201CR (DC)
AC/DC power
(RKW12-13RE)
FL1
(FL-205A)
Ship’s Main
100-240VAC
F1: 2A
TB1
DVI
(SXGA)
LCD panal
NL128102AC31-02
LCD I/F Board
Inverter Board
DVI I/F Board
(SLB-FRN3-A)
+12V
+24V
RC+
RC-
Power ON +5V
Data/CLOCK
Power ON +5V
DC/DC Board
(03P9359)
FL1
(MXB-1206-33)
Ship’s Main
DVI
(SXGA)
LCD panal
NL128102AC31-02
LCD I/F Board
Inverter Board
DVI I/F Board
(SLB-FRN3-A)
+12V
+24V
RC+
RC-
Power ON +5V
Data/CLOCK
24VDC
F1: 5A
TB1
Power ON +5V