Furuno FAR-2107 Series - Page 302

6.1 Self-test
6-7
Example: RF Monitor display
FAR-2827W, 2x27
Table 6.1.5 FAR-2827W: RF Monitor Display
Monitor Item L: 48NM M2: 6NM M1: 3NM S2: 1.5NM S1: 0.125NM
TUNE IND 1.6 1.6 1.5 0.7 1.0
R MONITOR 3.9 3.9 3.9 3.9 3.9
MAG
CURRENT
4.6 3.6 2.8 2.5 1.9
HEATER 1.4 1.4 1.7 1.7 1.7
TUNE OUT 16.0 16.0 16.3 16.2 16.2
FAR-2837SW, 2x37S
Table 6.1.6 FAR-2837SW: RF Monitor Display
Monitor Item L: 48NM M2: 6NM M1: 3NM S2: 1.5NM S1: 0.125NM
TUNE IND 1.5 1.7 1.6 1.4 2.6
R MONITOR 4.3 4.3 4.3 4.3 4.3
MAG
CURRENT
4.3 3.9 3.2 2.7 2.0
HEATER 1.5 1.5 1.5 1.8 1.8
TUNE OUT 9.9 10.0 10.1 10.1 9.8
Note:
HEATER voltage is displayed about 1.4 V in the RF MONITOR, but actual heater
voltages are from 7.4 V to 9.4 V. The checkpoint is J833 - #11(+), #12(-) on RF PWR.
See page 6-44.