Furuno FAR-2328 - How to restore a user customized echo to the factory default settings; How to edit the available customized echoes

1. OPERATIONAL OVERVIEW
1-46
1.28.4 How to restore a user customized echo to the factory default
settings
You can restore customized echo options to their factory default settings (see the ta-
bles on page 1-42 for a list of the default settings).
1. Open the menu.
2. Select [1 ECHO].
3. Select [2 CUSTOMIZED ECHO].
Note: You can also right-click the [PICTURE] box to access this menu.
4. Select [0 NEXT] to show the next menu page.
5. Select [3 DEFAULT].
6. Select [FACTORY].
1.28.5 How to edit the available customized echoes
To edit which customizations are available from the [CUS-
TOMIZE ECHO] box, follow the procedure below.
1. Open the menu.
2. Select [1 ECHO].
3. Select [0 NEXT].
4. Select [3 SELECT CUSTOM]. The [SELECT CUS-
TOM] menu appears.
5. Select the customization you want to edit.
The customizations are listed over two menu pages.
Select [0 NEXT] to see the next page, or select [1
BACK] to return to the previous menu page.
6. Select [ON] to make the customization available from
the [CUSTOMIZE ECHO] box, or select [OFF] to hide
the customization from the [CUSTOMIZE ECHO] box.
7. Close the menu.
Page 1
Page 2