Furuno FAR-2338-NXT - How to fasten the antenna unit to the mounting platform

1. INSTALLATION
1-22
3. Insert four stud bolts (M420, supplied) to the bolt holes at the bottom of the unit.
Note: Insert the stud
bolts manually. If you in-
sert the stud bolts using a
tool, the unit may be
damaged.
4. Set the unit to the mount-
ing location so that the
stud bolts on the bottom
of the unit are inserted to
the pilot holes.
5. Fasten the four wing nuts (supplied) to the stud bolts from the rear side of the
mounting surface.
1.4.2 Flush mount Installation
Note: For flush mounting in a panel, the mounting surface must be flat. Do not install
the unit on an uneven surface.
Flush mount, fixed at rear (for RCU-014/015/016)
Use the optional flush mount kit FP03-09870 to mount the Control Unit to a console
panel. See the outline drawing at the back of this manual.
Stud bolt
(4 pcs)
Ground
wire
*
: Use the screw that is
preattached to the
ground terminal.
Ground screw*
Wing nut
(4 pcs)