-1.
2-
1.2 Transmitter ON
When the STANDBY status is displayed on the screen, press the transmit switch labeled
STBY/TX on the control panel of the display unit.
The radar is initially set to previously used range and pulsewidth. Other settings such as
brilliance levels, VRMs, EBLs and menu option selections are also set to previous settings.
The transmit switch toggles the radar between STANDBY and TRANSMIT status. The
antenna stops in STANDBY status and rotates in TRANSMIT status.
Quick Start
Provided that the radar was once in use with the transmitter tube (magnetron) still warm, you
can turn the radar into TRANSMIT condition without 3-minutes standby. If the Power Switch
has been turned off by mistake or the like and you wish to restart the radar promptly, turn on
the Power Switch not later than 10 seconds after power-off.
Notes:
1) If the antenna does not rotate in TRANSMIT status, check whether the antenna switch in
the tuning compartment is in the OFF position.
2) The magnetron ages with time resulting in a reduction of output power. It is highly
recommended that the radar be set to STANDBY status when not used for an extended
period of time.
To Next Page
Loading...
Need help?
General
