11-1
11 NBDP TRANSMITTING,
RECEIVING
This chapter mainly shows you how to transmit and receive telex messages.
11.1 Manual Calling
NOTICE
Before calling, watch the intended TX
frequency carefully to confirm that is
unoccupied.
The simplest way to communicate with a telex subscriber is Manual Calling. For the ARQ
mode, you may display beforehand the message to send, or type your message manually.
1. Press the function key [F3] to display the Operate menu.
1: Call Station
3: File to Send
4: Cancel Sending
5: Scan (Start/Stop)
6: Manual Reception
7: Timer Operation
8: Manual Calling
9: Set Frequency
Operate
2: Macro Operation
Operate menu
2. Press the [9] key to choose Set Frequency.
Set Frequency
Tx Freq: 0.00
RX Freq: 0.00
Set frequency screen
3. Input Tx and Rx frequency pair.
4. Press the [Enter] key.
5. Press the function key [F3] again and then the [8] key to choose Manual Calling. The
following screen appears.
To Next Page
Loading...
