Furuno FS-1570 - Page 174

11 NBDP TRANSMITTING, RECEIVING
11-14
Procedure for preparing a macrofile for store-and-forward method
You will need a macrofile to enable automatic message transmission by store-and-forward
method. After preparing it, save it to a floppy disk for future use.
1. Press function key [F1] to display the File menu.
2. Press the [1] key.
3. Prepare macrofile. Below is simple example.
< [1] UNTITLED1 >
@FREE $RRR$
@CALL S:LYNGBY RADIO
@WRU
@CASE GA+?
@SEND TLX80212345+
@CASE MSG+?
@SEND B: ABC
@SEND KKKK
@CASE GA+?
@SEND BRK+
1
2
3
4
5
1 Search dot pattern free signal until it is found
2 Station name (Example: LYNGBY RADIO)
Who are you?
Station identity exchange
3 Subscriber's Telex number (in example, 802 is country
code of Hong Kong) for store-and-forward method
4 Location and name of file message
B: ABC (IB-581), A: ABC (IB-583)
5 Request for termination of message
Sample macrofile for store-and-forward method
4. Press function key [F1] to display the File menu.
5. Press the [3] key. The Close Text appears on the display.
close Text
Save File?
(UNTITLED 1)
No
Yes
Close text prompt