Furuno FS-2570 - 4.3 DIP Switch Settings for Updates

5. CALLING, RECEIVING
5-41
PSTN call connected.
DSC FREQ : 12230.0 KHZ
TO COAST : 001234567
TEL NO. : 1234567890123456
TELEPHONE CH 12001
PSTN end of call
in progress!
TIME TO GO: 8S
TO COAST :
001234567
TEL NO. : 1234567890123456
DSC FREQ : 12230.0 KHZ
PSTN call connected Waiting for acknowledgement PSTN end of call
Waiting for
acknowledgement.
TIME TO GO: 25S
DSC FREQ : 12230.0 KHZ
FROM COAST : 001234567
TEL NO. : 1234567890123456
TELEPHONE CH 12001
4) Follow the instructions below depending on the message shown in 3) above.
PSTN call connected: Your phone rings; pick up the handset and communicate with
the receiving station.
Waiting for acknowledgement: If the call is acknowledged, the message “PSTN call
connected.” appears. Follow “PSTN call connected” above.
PSTN end of call in progress: This means channel could not be used. After the timer
counts down to zero repeat this procedure to re-send the call.
Unable acknowledge call received
1) The audio alarm sounds; press the [CANCEL] key or [ENTER] knob to silence the alarm.
The display shown below appears.
*
Received message
*
MAR-23-2002-23:01 ECC: OK
UNABLE ACKNOWLEDGE
FROM COAST : 001234567
TEL NO. : 1234567890123456
BUSY
GO TO ALL VIEW
2) Press the [CANCEL] key to return to the DSC standby screen. Try the call again later.
No response! Try calling again?
Re-send call: Push the [ENTER] knob followed by the [CALL] key.
Cancel call: Press the [CANCEL] key to return to the DSC standby screen.