9 NBDP PREPARATIONS
9-6
Note 3: You may register 10 timer program. When you attempt to enter more, the message
“Timer operation memory is full. Press any key to escape.” Appears. Press any key
to escape. Delete unnecessary programs to enter new ones.
9.3.2 Editing/Deleting timer programs
1. Press the function key [F5] and the [2] key.
2. Press the [→] key to choose timer program from the Timer Operation List.
3. Press the [↓] key to choose Change and press the [Enter] key.
4. Do one of the following;
Edit program: Use [↑], [↓] and the [Backspace] key to make corrections.
Delete program: Erase operation name with the [Backspace] key.
5. Press the [Enter] key twice.
6. Press the [Esc] key.
9.4 User Channels
The user channel list provides storage for up to 100 user channels, numbered 0-99. Note
that user channels may be used in channel scanning.
9.4.1 Registering user channels
1. Press the function key [F5] and then the [4] key to show the User Channel Entry screen.
User Channel Entry
Create
Change
Channel List
Channel Set Up
Channel :
Tx Freq : 0.00
Rx Freq : 0.00
User channel entry screen
2. If Create is not underlined, press [→], [↑] and the [Enter] key to underline it.
3. Enter channel number in the Channel field.
4. Press the [↓] key to choose “Tx Freq.” Enter TX frequency.
5. Press the [↓] key to choose “Rx Freq.” Enter RX frequency.
6. Press the [Enter] key. Confirmation message appears.
7. Press the [Enter] key. Channel number entered appears in the Channel List.
To Next Page
Loading...
