3. INITIAL SETTINGS
13
6. Select BEACON FREQUENCY by the cursor pad.
7. Press the EDIT soft key to display the following window.
BEACON FREQUENCY
▲
AUTO
MANUAL 284.0 kHz
▼
▼
Beacon frequency window
8. Select AUTO or MANUAL by the cursor pad. When you select MANUAL, operate the
cursor pad to move the cursor to frequency dialog box. And press the arrow key to select
the frequency desired.
9. Press the [ENTER] key.
10. Select BEACON BAUD RATE by the cursor pad.
11. Press the EDIT soft key to display the following window. Beacon baud rate cannot be set
when BEACON FREQUENTRY is set to AUTO.
BEACON BAUD RATE
▲
200
100
50
▼
Beacon baud rate window
12. Select beacon baud rate corresponding to DGPS reference station to use.
13. Press the [ENTER] key.
14. Press the [PLOT] key to return the plotter display.
To Next Page
Loading...
