4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650W)
15
Disassembly
Procedure
1. Turn off the power. Wait at least one minute before opening the cover, to allow
capacitors to discharge.
2. Remove nuts attached to DGPS, NMEA and power supply connectors at the rear of the
display unit.
Screws X 6 A
Screws X 6 B
Nut
Nut, washer
Panel/chassis assembly
Cover assembly
Connector gasket
WARNING
Do not connect the power
cable with the cover re-
moved.
Removing cover assembly
3. Remove nuts and washer attached to ANT connector.
4. Remove twelve screws at rear of the display unit to detach panel/chassis assembly from
cover assembly.
Discard six screws
A
(3X12).
To Next Page
Loading...
