1. SYSTEM INTRODUCTION
1-9
1.9.2 How to erase an MOB mark
Tap the range/bearing indication at the bottom-right of the screen to show the pop up
window. Tap [Cancel MOB]. A confirmation message appears. Tap [Yes] or [No] as
appropriate.
1.10 Wireless LAN Setup
You can use the wireless LAN to update weather information and software.
Notice regarding use of wireless LAN
• The wireless LAN function is available only in the countries which have acquired ra-
dio wave certification. Turn this function off in countries which do not have radio
wave certification. Ocean-going vessels that have radio wave certification can use
the wireless LAN function in any country that has acquired radio wave certification.
Vessels with radio wave certification that enter a country that does not have radio
wave certification may use the wireless LAN function only onboard the vessel.
Available countries (as of March, 2018): USA, Canada, New Zealand, Australia, Ja-
pan, and all countries of the EU.
• The communication rate and effective range for the wireless LAN can be affected
by electromagnetic waves, interfering objects, or access point location.
• We strongly recommend using a wireless LAN with encrypted connection. Other-
wise unauthorized access by a third party can occur, which can cause loss of data
or system crash.
• We recommend changing the initial password when using a local wireless network.
1. Tap the [Home] icon to show the [Home] screen, then tap [Settings] => [General]
=> [Wireless LAN].
2. Tap the toggle box inside the [Wireless LAN Connection] section to show [ON].
The system checks for available wireless networks and shows them in the [Net-
works] list.
3. Tap the network you wish to connect to. The password input screen appears.
4. Input the network password, then tap [OK]. If the password is correct, the system
connects to the selected network.
5. Tap the [u] icon at the top-right corner of the menu to close the menu.
1.11 Simulation Mode
You can use the simulation mode to familiarize yourself with the system and opera-
tions. For safety, simulation mode should only be used when the boat is moored.
1. Tap the [Home] icon to show the [Home] screen, then tap [Settings] => [General]
=> [Simulation]. The simulation settings appear on the right-hand side of the
screen.
2. Tap the toggle box at [Simulation] to show [ON]; simulation mode is now active.
3. Tap [Mode], then select the required simulation mode. For the purpose of this pro-
cedure, select [Simulation].
• [Internal Slide Show]: Used for promotional purposes.
To Next Page
Loading...
