Furuno LH-5000 - Setting the Key Beep

LH-5000 Operator’s Manual
Operation Overview
36
A short tone sounds from the selected intercom speaker and the
corresponding information appears on the screen.
Step 2 Press the PTT key on the microphone and speak into it.
Step 3 Release the PTT key to receive.
Step 4 After finishing your conversation, press the same selected key from
IC 1 to IC 6 to return to the siren mode.
Talking with all intercom speakers in the siren mode
Step 1 Press and hold any key from IC 1 to IC 6 on the front panel for two
seconds.
All keys from IC 1 to IC 6 light red and a short one sounds from all
the intercom speakers.
Step 2 Press the PTT key on the microphone and speak into it.
Step 3 Release the PTT key to receive.
2.15 Setting the Key Beep
Step 1 Press the MENU key on the front panel.
Step 2 Press the Up or Down key to select "KEY BEEP" and press the ENT
key.
Step 3 Press the Up or Down key to select "ON" or "OFF" and press the
ENT key.
 ON: You hear the beep when pressing the key on the front panel.