What to do if FLIR is detected but CGI service is not available on Furuno Fish Finder?
If you receive a message indicating that the Nexus CGI Interface is not properly set for the TZTL12F/15F network on your Furuno Fish Finder, ensure that all Nexus CGI Interface settings are complete, especially Steps (12) to (13), as detailed in Section 3-2.
How to troubleshoot 'No FLIR Detected' on Furuno Fish Finder?
If your Furuno Fish Finder is not detecting FLIR, check the following: * Verify that appropriate static IP addresses have been assigned to the FLIR M-Series camera and JCU. * Ensure that LAN cables for the FLIR M-Series camera and JCU are properly connected to an Ethernet hub or PoE injector without loose connections. * If the issue persists after these checks, review the Nexus Server setting.
General| Display Size | 15.6 inches |
|---|---|
| Touchscreen | Yes |
| Brightness | 1000 cd/m² |
| Power Supply | 12-24 V DC |
| Display Type | LCD |
| Interface | Ethernet, NMEA 2000, NMEA 0183 |
| Operating Temperature | -15°C to +55°C |
| Storage Temperature | -20 to +70 °C |
| Resolution | 1366 x 768 pixels |
To Next Page
